Use and Care Manual

INSTALLING THE SHELVES:

1. Open the door completely.

2. Ensure that the metal guide posts are attached to the rear of the shelf.

3. Tilt the shelf 45° counterclockwise. The metal guide post on your left side should rest on the shelf track.

4. Gently push the shelf back towards the rear of the unit until the right side metal guide post meets the

vertical indentation in the plastic interior cabinet.

5. Gently set the right side of the shelf down on the shelf track. The shelf should move forwards and

backwards smoothly.

REMOVING THE SHELVES:

1. Open the door completely.

2. Make sure the shelf is pushed back completely.

3. Lift either the left or right side of the shelf to create a 45° angle from its original position. Make sure not

to lift either side of the shelf too hard as it may come in contact with the inner wall mount.

4. Pull the shelf outward until it is removed from the inner compartment. You may encounter some

resistance from the shelf guard rail.

Tip: To prevent damaging the door gasket, make sure to open the door fully before pulling the shelves out

of their track.

Note: The refrigerator may experience decreased cooling efficiency if air flow is restricted due to a fully

loaded cabinet.