Use and Care Guide

2
Important Safety Information
Improper handling can cause serious damage to the Avallon beverage refrigerator and/or injury to the user. This
beverage refrigerator is designed for domestic indoor use only. Do not use the unit for industrial or commercial use.
Any other use may invalidate the warranty. Please review the rating label located on the rear panel of the unit for
electrical and other technical data related to this unit. The unit must be used in a properly grounded wall outlet. Please
read and follow the safety information listed below to reduce the risk of fire, electric shock, or injury.
ELECTRICAL SAFETY
• Do not exceed the power outlet ratings.
• It is recommended the beverage refrigerator be connected on its own circuit.
• The unit must be installed in accordance with state and local electrical codes.
• A standard electrical supply (115 V, 60Hz), that is properly grounded in accordance with the National Electrical Code and local
codes and ordinances is required.
• Use outlets that cannot be turned off by a switch or pull chain.
• Always turn the unit off and unplug it from the outlet when cleaning.
• Unplug the unit if it is not going to be used for an extended period of time.
• Do not operate the unit with a power plug missing the ground plug, a damaged cord, or a loose socket.
• Be sure the beverage refrigerator is properly grounded.
• Never plug or unplug the unit with wet hands.
• Do not bypass, cut, or remove the grounding plug.
• Do not use extension cords or power strips with this unit. You may need to contact your electrician if it is necessary to use a
longer cord or if you do not have a grounded outlet. Do not modify the power cord’s length or share the outlet with other
appliances.
• Do not start or stop the unit by switching the circuit’s power on and off.
• If the power cord is damaged, it must be replaced by the manufacturer or a qualified technician.
• Never repair the unit while it is plugged in.
• Immediately unplug the unit if it makes strange sounds, emits smells or smoke comes out of it, and contact customer service.
• Do not remove any part of the casing unless instructed by an authorized technician.
• You should never attempt to repair the unit yourself. Contact customer service for service options if the unit needs service.
GENERAL SAFETY
• To prevent back and other types of injuries, use at least two people to move and install the beverage refrigerator.
• This appliance is not intended for use by persons, including children, with reduced physical, sensory or mental capabilities,
unless they have been given supervision or instruction concerning the use of the appliance by the person(s) responsible for their
safety.
• Install the beverage refrigerator in a well ventilated area where the ambient temperature is above 50°F and below 90°F.
• The temperature range for this refrigerator is optimized for beverage storage. Perishable food items may require a different
storage environment.
• Do not place hot or warm items into the beverage refrigerator before they cool down to room temperature.
• This unit is designed to be installed indoors, and protected from rain, sleet, snow, and/or moisture.
• Never allow children to crawl inside the beverage refrigerator. If disposing the unit, remove the door.
• Do not use this appliance near flammable gas or combustibles, such as gasoline, benzene, thinner, etc.
• Do not place the unit near heat sources such as ovens, grills, or direct sunlight.
• Only use in an upright position on a flat, level surface and provide proper ventilation.
• Do not pinch or kink the power supply line between the unit and cabinet.
• Do not place any other appliances on top of the unit.
• Do not turn the unit upside down, on its side, or at an angle off level.
• If your model beverage refrigerator is equipped with a lock, take care to keep the keys away from children.
• Do not move the unit without emptying the contents and securing the door in a closed position.
NOTE: Flammable Refrigerant Used! When handling, moving and using the refrigerator: make sure to avoid either
damaging the refrigerant tubing, or increasing the risk of a leak.