Use and Care Guide

7
Installing Your Beverage Refrigerator Continued
INSTALLING:
When installing the beverage refrigerator under a counter, follow the recommended spacing dimensions shown.
• To ensure proper service access and ventilation, allow
between 2-3 inches of clearance at the back as shown
in the diagram.
• The installation should allow the unit to be pulled
forward for servicing, if necessary.
• A standard electrical supply (115 VAC only, 60 Hz),
properly grounded in accordance with National
Electrical Code and local codes and ordinances is
required.
IMPORTANT: Once you are ready to install it in a
cabinet or directly on the floor, you must adjust the
feet to level the beverage refrigerator.
LEVELING:
The beverage refrigerator should be installed on a firm and level surface that will be able to support the entire weight of
a fully loaded unit. It is important for the beverage refrigerator to be leveled in order to work properly. It can be raised
or lowered by rotating the plastic sheaths around each of the feet on the bottom of the machine. If you find that the
surface is not level, rotate the feet until the beverage refrigerator becomes level. You may need to make several
adjustments to level it. We recommend using a carpenter’s level to check the machine. Turn the leveling feet to the
right to lower that side of the refrigerator. Turn the leveling feet to the left to raise that side of the refrigerator.
RECOMMENDED GROUNDING METHOD:
For your personal safety, this appliance must be grounded. It is equipped with a power supply cord having a 3-prong
grounding plug. To minimize possible shock hazard, the cord must be plugged into a mating 3-pronged wall socket, and
grounded in accordance with the National Electrical Code and local codes and ordinances. If a mating wall socket is not
available, it is the personal responsibility of the customer to have a properly grounded, 3-prong wall receptacle installed
by a qualified electrician.
ELECTRICAL SHOCK HAZARD!
• Plug into a grounded 3-prong outlet
• Never remove the grounding prong from the plug
• Never use an adapter to bypass the grounding prong
• DO NOT use an extension cord
• Failure to follow these instructions can result in fire, electrical shock, or personal injury
Before you move your beverage refrigerator into its final location, it is important to make sure you have the proper
electrical connection. A standard electrical supply (115 V, 60Hz), properly grounded in accordance with the National
Electrical Code and local codes and ordinances, is required. It is recommended that a separate circuit, serving only your
beverage refrigerator, be provided. Use receptacles that cannot be turned off by a switch or pull chain.
The fuse (or circuit breaker) size should be 15 Amps.