Use and Care Guide

9
This beverage refrigerator has a
temperature range from 34°F to 50°F
Operation
INSTALLATION CHECK-LIST BEFORE OPERATION:
1. Have all packing materials and tape been removed from the interior and exterior of the beverage refrigerator?
2. Have the installation instructions been followed, including connecting the machine to electricity?
3. Has proper grounding been installed for the beverage refrigerator?
4. Has the machine been leveled?
5. Is the beverage refrigerator in a site where the ambient temperature is between 50º F and 90º F all year round?
6. Is there a clearance of at least 2 to 3” at the rear for proper air circulation?
USING YOUR CONTROL PANEL:
POWER BUTTON: Press and hold down for three seconds to power your unit on. Once pressed
the “Run” indicator light will illuminate to indicate the unit is on and running. Press and hold for
three seconds again and the unit will power off and the “Run” Indicator light will turn off.
INCREASE TEMPERATURE: Press this button to increase the temperature by one (1) degree
increments. 50°F is the highest temperature on this unit.
DECREASE TEMPERATURE: Press this button to decrease the temperature by one (1) degree
increments. 34°F is the lowest setting on this unit.
INTERIOR LIGHT: Press this button to cycle through the different internal light settings. There
are four light settings - Constant Blue, Constant White, Automatic Blue, and Automatic White.
Press this button to cycle through the different light settings. The lights will fade as the unit
transitions between light settings. Press and hold this button for three seconds to turn the
light on/off. Open and close the door to check the color and the current setting. Please refer
to the “Internal Light” section on the next page for further details.
NOTE: Pressing and holding the increase and decrease temperature buttons at the same time will switch the temperature
display from °F to °C.
TIP: If you powered off the unit, please wait at least five (5) minutes before powering it back on.
WARNING: Allow at least 24 hours for your beverage refrigerator to run before storing your beverages and to allow the
temperature to acclimate. Whether your beverage refrigerator can reach the actual set temperature depends on the
ambient environmental conditions.