Use and Care Guide

Internal Light

This refrigerator is equipped with top and side internal lights that can be set to a blue or white color.

Because the unit comes with a glass door, the inside will be seen whether the door is open or closed. You

can choose to display each color of light in two different modes: Constant Mode and Automatic Mode.

Constant Mode

The internal lights will stay constantly illuminated whether the door is open or closed.

Automatic Mode

The internal lights will illuminate each time the door is opened and fade off once the door is closed. This

feature is triggered by a sensor located on the front vent. This sensor allows the refrigerator to recognize

when the door is open or closed.

With each press of the light button, the unit will progress through the cycle of light settings seen below.

Holding the light button for three seconds will turn the lights completely off or back on. If you power the

lights off they will remain off, even when the door is open. Hold the light button for three seconds again to

turn the lights back on.

Door Ajar Alarm

This wine and beverage refrigerator includes a door ajar alarm, which will sound if one of the doors is open

for more than five (5) minutes. Leaving the door open for extended periods of time will cause poor cooling

performance and may shorten the life of the refrigerator. Keep the doors closed as frequently as possible.

Warning: Allow at least 24 hours for your wine and beverage cooler to run before storing your beverages to

allow the temperature to acclimate. Whether your wine and beverage cooler can reach the actual set

temperature depends on the ambient environmental conditions.

Note: We run test every unit that we produce in our factory. Because of this, your model may default to

any of the above settings out of the box. Simply cycle through the progression of settings until you reach

your desired light setting. The lights will return to the Constant Blue setting after the Automatic White

setting, thus starting back at the beginning of the progression.

Tip: Close the door to determine if the light is currently in Constant Mode or Automatic Mode. In Constant

Mode the lights will remain on, and in Automatic Mode the lights will fade off once the door is closed.