USER’S GUIDE Installation, Operation, and Maintenance for your product. Built‐In Wine and Beverage Refrigerator Model – AWBC241GGFDBLSS www.avallon.com V2.
Important Safety Information Improper handling can cause serious damage to the Avallon wine and beverage refrigerator and/or injury to the user. This wine and beverage refrigerator is designed for domestic indoor use only. Do not use the unit for industrial or commercial use. Any other use may invalidate the warranty. Please review the rating label located on the rear panel of the unit for electrical and other technical data related to this unit. The unit must be used in a properly grounded wall outlet.
GENERAL SAFETY To prevent injuries, use at least two people to move and install the beverage refrigerator. Install the beverage refrigerator in a well‐ventilated area where the ambient temperature is above 50° F and below 90° F. The temperature range for this refrigerator is optimized for beverage storage. Perishable food items may require a different storage environment.
Table of Contents Important Safety Information ................................................................................................................................................. ii Table of Contents .................................................................................................................................................................... iv Introduction .....................................................................................................................
First Time Operating Instructions: Before use, make sure all packaging labels and materials are removed from the unit. Be sure to keep track of all included parts and pieces before discarding packaging materials. It is advised that you keep the original box and packaging materials in case you need to move or ship the appliance in the future. Allow the unit to stand for at least 24 hours before you use it; this allows the cooling components time to settle from transit.
Introduction Thank you for purchasing your Avallon wine and beverage refrigerator. Avallon is dedicated to developing products that will enhance your lifestyle with superior quality and distinctive features. Please visit www.avallon.com for more information on your product and other Avallon products. This manual contains important information regarding the proper installation, use, and maintenance of your wine and beverage refrigerator.
Parts Identification Back View 2
Carbon Filter A built‐in carbon filter protects your wine and beverages by acting as a natural barrier against harmful odors. Internal Fan This is an air‐cooled unit equipped with an internal fan that maintains a consistent internal temperature. Note: The carbon filter should be replaced every 3‐6 months depending on the unit’s exposure level to odor. If the unit is placed in a kitchen, regular replacement every three (3) months is ideal.
Warning: Use two or more people to move and install the wine and beverage refrigerator. Failure to do so can result in back or other injury. Carefully remove the packaging materials. Remove any shipping tape and glue from your wine and beverage refrigerator before using. Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue. These products can damage the surface of your wine and beverage refrigerator.
Installation Clearance Requirements: When installing the wine and beverage refrigerator under a counter, follow the recommended spacing dimensions shown. • To ensure proper service access and ventilation, allow between 1 ‐ 2 inches of clearance at the back as shown in the diagram. • The installation should allow the unit to be pulled forward for servicing, if necessary.
RECOMMENDED GROUNDING METHOD: For your personal safety, this appliance must be grounded. It is equipped with a power supply cord having a 3‐prong grounding plug. To minimize possible shock hazard, the cord must be plugged into a mating 3‐ pronged wall socket, and grounded in accordance with the National Electrical Code and local codes and ordinances.
INSTALLING THE SHELVES: Left Zone 1. Open the door completely. 2. Push the shelf tracks affixed to the walls of the inner cabinet to the rear of the unit so that the tracks are fully seated inside the cooler compartment. 3. Line up the rails affixed to the shelf with the corresponding wine and beverage cooler tracks attached to the inner cabinet walls. 4. Push the front of the shelf inwards evenly until the shelf rests fully inside of the unit and you are able to close the door. 5.
Right Zone 1. Open the door completely. 2. Make sure the shelf is pushed back completely. 3. Lift either the left or right side of the shelf to create a 45° angle from its original position. Make sure not to lift either side of the shelf too hard as it may come in contact with the inner wall mount. 4. Pull the shelf outward until it is removed from the inner compartment. You may encounter some resistance from the shelf guard rail.
USING YOUR CONTROL PANEL: Each independently controlled temperature zone – right and left – contains its own control panel. The right (beverage) zone has a temperature range of 34° F to 65° F. The left (wine) zone has a temperature range of 40° F to 65° F. Power Button Press and hold this button down for three seconds to power your unit on. Once pressed, the “Run” indicator light will illuminate to indicate the unit is on and running.
Warning: Allow at least 24 hours for your wine and beverage refrigerator to run before storing your wine and beverages and to allow the temperature to acclimate. Whether your wine and beverage refrigerator can reach the actual set temperature depends on the ambient environmental conditions. Internal Light This refrigerator is equipped with top and side internal lights that can be set to a blue or white color.
Defrosting The refrigerator will automatically defrost under most temperature settings and ambient conditions. However, on colder settings, some frost may build up. Additionally, under more humid ambient conditions, more frost may build up. Keep the door closed as much as possible and avoid opening the door unnecessarily to minimize frost build‐up. If frost is preventing the door from closing properly, you may need to power the unit off until the frost melts. Use a soft absorbent towel to dry the unit.
Cleaning and Maintenance Periodic cleaning and proper maintenance will ensure efficiency, top performance, and long life. INTERIOR CLEANING: 1. 2. 3. 4. 5. 6. Disconnect power to the unit. Open the door and remove the contents and shelves. Wait until the unit defrosts. With a clean cloth, wipe down the interior of the unit. Reinsert the shelves and wine and beverages. Reconnect power to the unit. EXTERIOR CLEANING: The door and cabinet may be cleaned with a mild detergent and lukewarm water solution.
Troubleshooting ISSUE The wine and beverage refrigerator turns on and off frequently. The wine and beverage refrigerator does not turn on. POSSIBLE CAUSE The room temperature is higher than the recommended ambient environment. The door is being opened often. SOLUTION Run the refrigerator at the appropriate ambient temperature. Minimize the number of times the door is opened. The door is not completely closed. Make sure the door is completely closed.
ISSUE The wine and beverage refrigerator will not reach the desired temperature. POSSIBLE CAUSE The refrigerator has restricted air flow due to too much storage. The refrigerator is placed too close to a heat source. The refrigerator does not have sufficient ventilation. The door is opened too frequently or for long periods of time. The wine and beverage refrigerator is making strange noises. Certain sounds are normal The body of the wine and beverage refrigerator is electrified.
Specifications DESCRIPTION OF PRODUCT Dual Zone Built‐In French Door Wine and Beverage Refrigerator MODEL AWBC241GGFDBLSS VOLTAGE / FREQUENCY AC 115 / 60 Hz AMPERAGE 1.5 A INPUT POWER 130 W COLOR Black Cabinet with Black Stainless Steel Door STORAGE CAPACITY 21 Bottles and 64 Cans* REFRIGERANT R600a, 1.41 oz.
Avallon Product Warranty Warranty Period 1st year Limited 2nd‐5th year (compressor only) Avallon will be responsible for: All costs for repairing or replacing parts and/or unit which proves to be defective. All transportation costs in the first 90 days. Repairing or replacing any compressor which proves to be defective. (Labor not included) Consumer will be responsible for: All transportation costs after 90 days. Labor and all transportation costs.
