Owner's Manual (Black Stainless Steel)

5
Installation Clearance Requirements:
When installing the wine refrigerator under a counter, follow the recommended spacing dimensions shown.
• To ensure proper service access and ventilation, allow between 1 - 2 inches of clearance at the back as
shown in the diagram.
• The installation should allow the unit to be pulled forward for servicing, if necessary.
• A standard electrical supply (115 VAC only, 60 Hz), properly grounded in accordance with National
Electrical Code and local codes and ordinances, is required.
LEVELING:
The wine refrigerator should be installed on a firm and level surface that will be able to support the entire
weight of a fully loaded unit. It is important for the wine refrigerator to be leveled in order to work properly.
It can be raised or lowered by rotating the plastic sheaths around each of the feet on the bottom of the
machine. If you find that the surface is not level, rotate the feet until the wine refrigerator becomes level.
You may need to make several adjustments to level it. We recommend using a carpenter’s level to check the
machine. Turn the leveling feet clockwise to lower that side of the refrigerator. Turn the leveling feet
counterclockwise to raise that side of the refrigerator.
Important: Once you are ready to install the unit in a cabinet or directly on the floor, you must adjust the
feet to level the wine refrigerator.