Installation Sheet

12
Installing the Shelves
Removing the Shelves
To prevent damaging door gasket, make sure to open the door fully before pulling the shelves o their tracks.
1. Open the door completely.
2. Push the shelf tracks axed to the walls of the inner cabinet to the rear of the unit so that the tracks are fully
seated inside the cooler compartment.
3. Line up the rails axed to the shelf with the corresponding tracks aached to the inner cabinet walls.
4. Push the front of the shelf inward evenly unl it rests fully inside the unit and you are able to close the door.
5. The shelf should glide smoothly back and forth. If it does not, you may need to remove it and start over.
1. Open the door completely.
2. Remove all of the contents loaded on the shelf, if applicable.
3. Pull the shelf towards yourself unl it is fully extended outward.
4. The shelf has plasc posts on both sides as indicated in the diagram below. While facing the unit, press the
plasc post on the right side down while pulling up on the le plasc post. You may choose to do this by hand or
by using a athead screwdriver.
5. Evenly pull out the shelf from the track unl it is completely removed from the inner compartment.