Owner Manual



8

InstallingYourDoorHandleandShelves



INSTALLINGTHEDOORHANDLE:

1. Openthedoorandcarefu lly pullthedoorgasketaroundtheareawherethehandleistobeinstalled.

2. InserteachPhillipsheadscrewthroughthegasketsideofthedooruntilthescrewpassthroughthedoor.

3. Alignthehandlewiththescrewsandtightenusinga

Phillipsheadscrewdriveruntilthehandleisflushagainstthe

doorframe.CAUTION:Donotover‐tightenthescrewsasthismaycausedamagetothehandleortothestainless

steeldoor.

4. Carefullypressthedoorgasketintoitsoriginalposition.



INSTALLINGTHESHELVES:

1. Openthedoorcompletely.

2. Pushtheshelftracksaffixedtothewallsoftheinnercabinettotherearoftheunitsothatthetracksarefullyseated

insidethecoolercompartment.

3. Lineuptherailsaffixedtotheshelfwiththecorrespondingwinecoolertracksattached

totheinnercabinetwalls.

4. Pushthefrontoftheshelfinwardsevenlyuntiltheshelfrestsfullyinsideoftheunitandyouareabletoclosethe

door.

5. Theshelfshouldglidesmoothlybackandforth.Ifitdoesnot,youmayneedtoremoveit

andstartover.



REMOVINGTHESHELVES:

1. Openthedoorcompletely.

2. Removeallofthecontentsloadedontheshelf,ifapplicable.

3. Pulltheshelftowardsyourselfuntilitisfullyextendedoutward.

4. Theshelfhasplasticpostsonbothsidesasindicatedinthediagrambelow.Whilefacingtheunit,presstheplastic



postontherightsidedownwhilepullingupontheleftplasticpost.Youmaychoosetodothisbyhan dorby usinga

flatheadscrewdriver.

5. Evenlypullouttheshelffromthetrackuntilitiscompletelyremovedfromtheinnercompartment.



TIP:Topreventdamagingthedoorgasket,makesuretoopenthedoorfullybeforepullingtheshelvesoutoftheirtrack.

