AB-ICE26 Portable Ice Maker OWNER’S MANUAL Read and save these instructions. Contact Us: 1-844-528-2566 www.avalon-bay.com support@avalon-bay.
Contents IMPORTANT SAFETY INSTRUCTIONS ......................................................... 3 Electrical Warnings ................................................................................... 3 Additional Safety Tips ............................................................................... 4 GETTING TO KNOW YOUR PORTABLE ICE MAKER ..................................... 4 Features ....................................................................................................
IMPORTANT SAFETY INSTRUCTIONS Your safety and the safety of others is very important. We have provided many important safety messages in this manual and on your appliance. Please read and obey all safety messages. Serious injury or even death can occur if these instructions are not carefully followed. Electrical Warnings Electrical Shock Hazard Improper use of the grounded plug can result in electrical shock. If the power cord is damaged, please contact customer service.
Additional Safety Tips Do not place hands or objects on or near the ice maker’s evaporator when it is in operation. Always turn off and unplug the ice maker from the power supply before cleaning and servicing. Exercise caution and make sure there is supervision when this appliance is being used near children. If the ice maker is brought in from the outside in the winter, allow the ice maker to warm up to your room’s temperature for a few hours before plugging it in.
List of Main Parts 1. 2. 3. 4. ICE SCOOP 6. WATER DRAIN CAP (LOCATED ON ICE FULL SENSOR THE FRONT BOTTOM SIDE OF THE ICE BASKET UNIT) TOP COVER WITH 7. WATER LEVEL LIVE (REMOVE ICE TRANSPARENT WINDOW BASKET FOR A CLEAR VIEW OF THE 5.
The Control Panel A. Ice Size Indicators S = small L = large B. Power Indicator C. D. E. F.
ASSEMBLY & INSTALLATION IMPORTANT NOTICE! After unpacking your ice maker, it must rest in an upright position for at least one hour before you plug it in or the compressor may be damaged, shortening the life span of the unit. 1. Remove the exterior and interior packaging. Check that the ice basket and ice scoop are included. If any parts are missing, please contact customer service. 2. Clean the interior with lukewarm water and a soft cloth. Take out the ice basket and clean it.
OPERATING INSTRUCTIONS HOW TO MAKE ICE 1. Open the ice maker’s top cover, remove the ice basket and pour clean water into the reservoir. Keep the water level below the maximum water level line. 2. Press the ON/OFF button on the control panel to begin the ice making cycle. 3. Select the ice cube size by pressing the SELECT button. If the room temperature is lower than 60°F, we recommend selecting small size ice cubes in order to prevent ice from sticking together. 4.
CLEANING & MAINTENANCE HOW TO DRAIN YOUR ICE MAKER To drain the ice maker, position the drainage port on the bottom of the unit over a sink, or place a small container or receptacle under the drainage port. Remove the plug and allow water to drain out completely. Change the water in the water reservoir every 24 hours to ensure clean ice. If the unit will not be used for an extended period of time, drain all of the water from the reservoir and dry the reservoir and ice basket.
TROUBLESHOOTING PROBLEM The “ADD WATER” indicator light is on. POSSIBLE CAUSE There is not enough water in the tank. The “ICE FULL” indicator light is on. There is too much ice in the basket. The ice making cycle appears to be normal but no ice is being produced. The room temperature or the water temperature in the inner tank is too high. The ice cubes stick together. The refrigerant may be leaking. A pipe in the cooling system may be blocked. The ice making cycle is too long.
The ice has a “plastic” taste. The unit’s interior may need to be cleaned. The ice cubes have a cloudy appearance. There may be trace minerals in your water or ice is being produced too quickly. Unit is not draining properly The drain plug is stuck inside the unit Add a tablespoon of lemon juice or vinegar to a full tank of water and allow the ice maker to cycle a few times. Ice cubes may develop cloudiness when water is frozen quickly.
DETAILED PARTS DIAGRAM 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. Power cord Back panel Metal plate Magnetism valve Evaporator Control box cover Main PCB Control box Ice making box Micro switch Inner tank bracket, LH Cam Ice scoop link 14. 15. 16. 17. 18. 19. 20. 21. 22. 23. 24. 25. 26. Ice scoop Back bottom panel Back top panel Clear window Displaying PCB Touch pad Front top panel Front bottom panel Ice basket Foaming arm Water filter Inner tank bracket, RH Synchronous motor 27. 28. 29. 30. 31.
Electrical Diagram Avalon Bay AB-ICE26 Series Portable Ice Maker
LIMITED MANUFACTURER’S WARRANTY This appliance is covered by a limited manufacturer’s warranty. For one year from the original date of purchase, the manufacturer will repair or replace any parts of this appliance that prove to be defective in materials and workmanship, provided the appliance has been used under normal operating conditions as intended by the manufacturer.