Full Product Manual

35
Troubleshooting
Dispense button is flashing and unit is beeping
If the dispense button is flashing and the unit is making a slight beeping sound,
it is alerting you that there may be a leak in the unit. Please refer to page 26.
Water leaking from unit
• Check to make sure that pipes are connected properly.
• Inspect the adapter to ensure that it is connected properly.
• Water pipe may need to be replaced.
Water not dispensing at a hot or cold temperature
This could be caused by an over consumption of water in a short period of time causing
the tanks to empty. Please allow 5 to 10 minutes for the water cooler tanks to refill. Allow
the proper time for the water to heat and cool.
This could be caused by an interruption in the power supply. Please ensure that the
power cord is connected to an outlet. Please make sure that the heating (#9) and
cooling (#8) switches are in the on (I) position.
If all the water in the unit has been dispensed quicker than the tanks can fill, you can siphon
water back into the tanks by holding the dispense button once a temperature is chosen until
water starts to dispense again.
All three temperature buttons blinking
This means that the inner water reservoir was emptied quicker than it was able to be refilled.
Wait 10 seconds until it can begin refilling again.
Troubleshooting