Owner`s manual

Maintaining Your Appliance 27
© Travis Industries 100-01252_000 4101004
Door Parts
1
2
7
3
4
5
6
8
10
9
ID # Description Qty Part # ID # Description Qty Part #
1 Glass Gasket 1 250-00173 2 Camano Glass 1 250-02073
3 Glass Clip w Gasket– 3 Hole 2 250-00174 4 Door Gasket 1 250-00178
5 RTV High Temp. 600° Silicone 6 Camano Door Handle Asbly 1 250-02074
7 Camano Door Handle (phenolic) 1 91001605 8 Door Washer 1 250-00364
9 Door Cam 1 250-00598 10 Screws (8) 8-32 x 1/2” Torx 1 225-20039
Replacing the Glass
The glass must not contact the door retainer or glass clips directly. The glass gasket and glass clip
gaskets insulate the glass to prevent cracking. Do not over-tighten the glass clips.
Replacing the Door Gasket
The door gasket inserts into the outer groove of the door. RTV High temp silicone holds it in place.
Before installing, remove any residual cement. Lay the gasket in place (start at the lower right corner)
and cut off any excess gasket (do not stretch the gasket. You may need to open and close the door
repeatedly to get the gasket to seat fully.
Replacing the Door Handle
See the illustration above for a component list (see pg. 25 for details on adjusting the door).
Removing the Door
The stove top must be removed to lift the door off the hinges. To remove the stove top, disconnect the
flue, remove the four screws securing this stove top to the back panel, and slide it forward away from the
stove. When re-installing, make sure the two clips under the stove top engage the slots on the front of
the stove.