Owner`s manual

48 Optional Equipment (for qualified installers only)

3 Unplug the ac adapter from the power harness (see Figure 5). You can leave the ac adapter plugged

into the wiring harness.

Figure 5

4 Disconnect the molex connector leading to the gas control valve (see Figure 6).

WARNING

: The tabs on the gas control valve are fragile. Take care when removing the molex

connector to not pull or damage the wires or tabs.

Figure 6

5 Disconnect the two leads on the back of the control panel for the IPI / CPI switch (continuous pilot /

greensmart pilot – see Figure 7).

Figure 7