ERS-CDV Fanless Intel® Atom™ D2550 Rugged Embedded System with Intel® NM10 Express Chipset Quick Reference Guide 1st Ed – 1 June 2012 Part No.
ERS CDV 1. Getting Started 1.1 Safety Precautions Warning! Always completely disconnect the power cord from your chassis whenever you work with the hardware. Do not make connections while the power is on. Sensitive electronic components can be damaged by sudden power surges. Only experienced electronics personnel should open the PC chassis. Caution! Always ground yourself to remove any static charge before touching the CPU card. Modern electronic devices are very sensitive to static electric charges.
Quick Reference Guide 1.3 System Specifications Specifications System Board ECM-CDV CPU Onboard Intel® Atom™ D2550 1.86GHz CPU BIOS AMI 16Mbit SPI BIOS System Chipset I/O Chip System Memory SSD Hard Disk Watchdog Timer H/W Status Monitor Intel® NM10 Express Chipset Nuvoton W83627DHG-P One 204-pin DDR3 SODIMM Socket Up to 4GB DDR3 800/ 1066 SDRAM 1 x CompactFlash Type I/II Socket 1 x 2.5” SATA HDD/ SSD Reset: 1sec. ~ 65535sec./min. and 1sec. or 1min.
ERS CDV &Mechanical Power Requirement ACPI Power Type Operating Temp. Storage Temp. Relative Humidity Vibration Protection Shock Protection +12V~+26V (+12V/ 5A Lockable DC Plug Adapter is an Accessory to This System) Single Power ATX Support S0, S3, S4, S5 and ACPI 3.0 Compliant AT/ ATX (ATX is the default setting) -10 ~ 60°C (w/ CF and 2.
Quick Reference Guide 1.4 System Overview 1.4.
ERS CDV 1.4.
Quick Reference Guide 2. Hardware Configuration Jumper and Connector Setting, Driver and BIOS Installing For advanced information, please refer to: 1- ECM-CDV Quick Installation Guide or User’s Manual Note: If you need more information, please visit our website: http://www.avalue.com.
ERS CDV 2.
Quick Reference Guide 2.2 ERS-CDV connector mapping 2.2.1 2.2.
ERS CDV 2.2.3 VGA connector (VGA) PIN Signal PIN Signal PIN Signal 1 R 6 GND 11 NC 2 G 7 GND 12 DATA 3 B 8 GND 13 HSYNC 4 NC 9 +5V 14 VSYNC 5 GND 10 EN# 15 CLK 2.2.
Quick Reference Guide 2.3 Installing Hard Disk & Memory Step 1. Unfasten 3 screws from bottom and rear side. Step 2. Remove the chassis cover. Step 3. Insert the drive into position, and secure with 4 screws. Step 4. Insert DDR3 SODIMM into memory socket. Step 5.
ERS CDV 2.4 Installing Mounting Bracket (Optional) Step 1. Fasten 6 screws on both sides of ERS Rugged Embedded System. .
