XTX-PNV Intel Pineview XTX Module Quick Installation Guide 1st Ed – 9 November 2010 Part No.
XTX-PNV Content 1. Getting Started ...........................................................................................................3 1.1 Safety Precautions ................................................................................................3 1.2 Packing List ...........................................................................................................3 2. Hardware Configuration ............................................................................................
Quick Installation Guide 1. Getting Started 1.1 Safety Precautions Warning! Always completely disconnect the power cord from your chassis whenever you work with the hardware. Do not make connections while the power is on. Sensitive electronic components can be damaged by sudden power surges. Only experienced electronics personnel should open the PC chassis. Caution! Always ground yourself to remove any static charge before touching the CPU card.
XTX-PNV 2.
Quick Installation Guide 2.
XTX-PNV 2.2 Jumper and Connector List You can configure your board to match the needs of your application by setting jumpers. A jumper is the simplest kind of electric switch. It consists of two metal pins and a small metal clip (often protected by a plastic cover) that slides over the pins to connect them. To “close” a jumper you connect the pins with the clip. To “open” a jumper you remove the clip. Sometimes a jumper will have three pins, labeled 1, 2, and 3.
Quick Installation Guide 2.3 Setting Jumpers & Connectors 2.3.1 AT/ATX mode/ AT/ATX power selection (SW1) AT/ATX Power AT power OFF 1 ON > 2 ATX power* OFF 1 2 ON = AT/ATX mode AT mode OFF > 1 ON 2 ATX mode* *Default OFF 1 = ON 2 2.3.1.1 Signal Description –AT/ATX mode/ AT/ATX power selection AT/ATX power / AT/ATX mode AT mode/ AT power Description Use AT power input, and set the board in AT mode. AT mode/ ATX power Use ATX power input, and set the board in AT mode.
XTX-PNV 2.3.2 Bypass / scaler Mode selection for LCD Mode (SW2) Bypass Mode selection X ON X 4 > 3 > 2 > 1 OFF Scaler Mode selection X ON X 4 > 3 = OFF 2 > 1 Scaler Mode selection* *Default X ON X = 4 3 > 2 > 1 OFF 2.3.2.
