Installation Instruction

SUGGESTED TOOLS AND MATERIALS

Philips Screwdriver Sealant Tape Measure Safety Glasses

10'

PARTS / HARDWARE (INCLUDED ONLY WITH AVANITY STONE TOPS)

500001

111212

SINK INSTALLATION

120003

Apply a continuous bead of quality sealant

to the top surface (rim) of the sink.

Turn the stone top upside down and place it on a clean,

scratch resistant surface. Center the sink over the cutout.

Secure the sink to the top using the mounting kit / hardware provided with the stone top, HAND TIGHTEN ONLY.

Apply bead of quality sealant evenly

along the top of the vanity.

Finally, place the bottom side of back splash with sealant onto the countertop and check

alignment of backsplash. Adjust the leg levelers as needed

Apply silicone sealant evenly along

the bottom of backsplash and wall.

All Sizes

INSTALLATION INSTRUCTION

STONE VANITY TOP

120004

**NOTE: Sink style, shape, cutout on top, vanity may vary from the picture above. Instructional purposes only. **

PAGE 1
INSTALLATION INSTRUCTION STONE VANITY TOP All Sizes SUGGESTED TOOLS AND MATERIALS 10' Philips Screwdriver Sealant Tape Measure Safety Glasses 4x 4x 500001 111212 120004 120003 PARTS / HARDWARE (INCLUDED ONLY WITH AVANITY STONE TOPS) 4x 4x SINK INSTALLATION 1 3 2 Apply a continuous bead of quality sealant to the top surface (rim) of the sink. Turn the stone top upside down and place it on a clean, scratch resistant surface. Center the sink over the cutout.
PAGE 2
Vanity Installation SUGGESTED TOOLS AND MATERIALS / OUTILS ET MATÉRIAUX PROPOSÉES 10' Tape Measure / Mètre à ruban INSTALLATION INSTRUCTIONS / Les instructions d'installation 1 2 Remove vanity from box and examine vanity for any defects or damage. Carefully place vanity against wall. 3 Install vanity top according to manufacturer’s directions.