Operation Manual

Operating instructions, cab
25
600 Series
ATTENTION!
NEVER DRIVE WITH THE CAB
DOOR OPEN. DO NOT TURN THE
STEERING WHEEL WHEN THE
CAB DOOR IS OPEN.
CAB
AVANT 600 series can be equipped with a cab. Here
the operating instructions for the cab:
All the other switches are located at the control panel
on the right side except the thermostat of the heater
which is located at the front panel on the left.
The windscreen washer tank is located under the
doorstep left, and the filler hole is under the carpet.
The fuse (25A) for electrical equipment of the cab is
located in the fuse box of the loader, under the front
cover plate (see page 23).
Heater
The cab is equipped with a warm water heater which
works like a central heating system, using the coolant
of the engine.
Cab temperature can be adjusted with the thermostat
on the front panel left.
Air flow can be directed with the nozzles on the front
panel and in the footwell.
Heating efficiency and air flow can be adjusted with
the fan.
The cab is also equipped with an air circulation system:
There is a ventilation hatch under the nozzle in the
footwell. The hatch is adjusted with two finger screws.
As soon as the hatch is opened the heating system
starts to take warm air from the cab and circulates it
through the nozzles back in the cab. This way the cab
warms up quicker in cold weather.
ATTENTION! Switch off the air circulation as
soon as the temperature in the cab is sufficient,
otherwise the cab keeps warming up and
moisture starts to condense on the windows.
The right side window of the cab can be opened in
order to improve circulation of air.
Safety
Familiarise yourself with the special drive features and
space needs of this articulated loader, equipped with
cab, on a flat, even and open place. Remember that,
when turning, the cab extends beyond the turning
radius of the wheels. This should be taken into
consideration especially when driving in confined
spaces, in order that the rear of the cab will not get
damaged.
ATTENTION! It is not allowed to drive and/or to
turn with the loader with the cab door open, otherwise
the glass door of the cab can break.
The cab is a certified ROPS/FOPS structure and
complies with the ROPS standards ISO 3471:1994
with Amendment 1:1997 and Technical Corrigendum
1:2000; and EN 13510:2000; and FOPS standard ISO
3449:2005 (1365 J).
Work light, front
Fan
Windscreen
wiper and
washer
Work light, rear
Emergency
blinker
Beacon
Ignition switch