FAQ

1/4"
7/8"
Cuts all sizes from 1/4" up to 7/8"
Most commonly used Dado sizes shown here. (Many other sizes possible - see below)
1/4" 3/8" 7/16" 15/32" 1/2" 17/32" 23/32" 7/8"
Aquí se muestran las medidas de mortaja comúnmente utilizadas. (Hay muchas otras medidas posibles - lea abajo)
www.DiabloTools.com
Chipper Set-Up & Configuration Guide
DD208 STACKED DADO SET
Use this chart to determine which components to stack to obtain the desired width of cut.
Utilice este cuadro para determinar que tipo de componentes superponer para obtener el ancho de corte deseado.
A
B
C
D
.004"
.008"
.012"
.020"
11 -11 -11 -11 22 333
-- 11 11 22 22 33 33 33 333
11 11 11 11 11 11 11 11 111
1
1
1 111 11 11 11 11 11 11 111
1111111111
1111111111
1
5
Blades
Chippers
Spacers
Shims
1/4"
5/16"
-
-
1
1
1
1
9/32"
11/32"
3/8"
13/32"
7/16"
15/32"
1/2"
17/32"
9/16"
19/32"
5/8"
21/32" 11/16" 23/32"
3/4"
25/32" 13/16" 27/32"
7/8"
Nominal Widths
A - Left Outside Blade (1) B - Right Outside Blade (1) C - 1/8" Two Wing Chipper (3) D - 1/16" Spacer (3)
A - Hoja exterior izquierda (1) B - Hoja exterior derecha (1) C - Astillador 1/8" (3) D - Espaciador 1/16" (3)
DD208-Chipper-Guide.ai 1 8/14/13 1:53 PM