Instruction manual

ManualsBrandsAvanti ManualsTelephones3015 set

IP-based Telephony Platform

AVANTI 3015ip TELEPHONE

INSTALLATION NOTES

CONTENTS

1. General ............................................................................................................. 2

2. Typographic conventions .................................................................................. 2

3. Avanti 3015ip installation architecture .............................................................. 3

3.1 Connecting the Avanti 3015ip through the WAN ................................................................ 3

3.2 PC connection ....................................................................................................................... 3

4. Installing the Avanti 3015ip .............................................................................. 4

5. Initial setup ....................................................................................................... 5

5.1 Setup controls ....................................................................................................................... 5

5.2 DHCP configuration principles .............................................................................................. 5

5.3 Automatic error detection ..................................................................................................... 7

5.4 The Setup Procedure ............................................................................................................. 8

The information in this publication refers to the Telrad UNITe IP family of telephone systems, including the UNITe IP I-100,

UNITe IP C-128, UNITe IP C-400 and UNITe IP C-1000 systems, Release e2e-1, as of January 2004. Telrad Connegy, Inc.,

reserves the right to make changes in the equipment described in this manual without notification. However, changes

in the equipment do not necessarily render this manual invalid.

Additional copies of this manual may be obtained from Telrad Connegy, Inc. Reproduction of this manual or parts thereof

without written permission from Telrad Connegy, Ltd., is strictly prohibited.

FCC Regulations - Warning for Installations in the USA

This equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with

the instruction manual, may cause interference to radio communications. Operation of this equipment in a residential

area is likely to cause harmful interference, in which case the user should contact the Telrad Connegy Field Service De-

partment, at the telephone number listed below, to correct the interference problem. It has been tested and found to

comply with the limits for a Class A computing device pursuant to Subpart J of Part 15 of the FCC Rules which are de-

signed to provide reasonable protection against such interference when operated in a commercial environment.

Summary of content (9 pages)

PAGE 1
IP-based Telephony Platform AVANTI 3015ip TELEPHONE INSTALLATION NOTES CONTENTS 1. General ............................................................................................................. 2 2. Typographic conventions .................................................................................. 2 3. Avanti 3015ip installation architecture .............................................................. 3 3.1 Connecting the Avanti 3015ip through the WAN ......................................
PAGE 2
Avanti 3015ip Installation Notes 1. GENERAL This document describes the procedures necessary for the installation and initial setup of the Telrad Connegy Avanti 305ip telephone. 2. TYPOGRAPHIC Bolded text in brackets indicates a fixed button on the Avanti 3015ip telephone, as in [SPEED DIAL/PROGRAM]. CONVENTIONS Bolded italic text in curly brackets indicates a softkey on the telephone, as in {YES}. The Courier font indicates text displayed on the Avanti 3015ip screen, as in TVS Menu. 3.
PAGE 3
Avanti 3015ip Installation Notes Figure 2 Connection to the WAN 3.2 PC CONNECTION A PC can be connected to the network through the Avanti 3015ip. In this case, the Avanti 3015ip is transparent to the PC operation. Calls arriving or made by the Avanti 3015ip do not affect PC operation, nor does this operation interfere with the Avanti 3015ip’s. When connecting a PC through the Avanti 3015ip, the data cable from the Avanti 3015ip (see Figure 4, below) connects to an Ethernet network card in the PC.
PAGE 4
Avanti 3015ip Installation Notes Power adaptor If Power-over-EtherNet is enabled, follow the instructions in Section 5.3 before inserting the data connector on the rear side jack of the Avanti 3015ip (see Figure 4). To network To PC Figure 4 Avanti 3015ip external connection sockets If this is the first time the Avanti 3015 ip is connected, perform the initial setup procedure. 5. INITIAL SETUP 5.1 SETUP CONTROLS During the setup process you are required to enter data, confirm your choices, etc.
PAGE 5
Avanti 3015ip Installation Notes Keys Meaning Softkeys When required to enter a value manually, remember that the leftmost softkey under the display accepts the present value and moves on to the next option, while the middle softkey returns you to the previous screen. 5.2 DHCP CONFIGURATION PRINCIPLES Section 4.11, “Working with DHCP” in the UNITe IP TVSe Server System Manual, contains a detailed explanation of the principles of configuration for DHCP support.
PAGE 6
Avanti 3015ip Installation Notes 5.4 THE SETUP PROCEDURE 1. To begin the Setup procedure, connect the Avanti 3015ip to the power source while at the same time holding down the [SPEED DIAL/PROGRAM] button. After a few seconds the display shows: Phone Configuration {Info} displays general phone information like the MAC address. {Boot} initiates the startup process. 2. Press {Edit} to enter the Setup procedure, The display shows IP Menu? The softkeys change to {YES} and {NO}.
PAGE 7
Avanti 3015ip Installation Notes NOTE If you attempt to type in a value greater than 255, the digits you entered will be displayed briefly then disappear. See above, Section 5.3. Once you enter the IP address, the display shows Network Subnet Mask [255.255. 0. 0] The subnet mask must always represent a sequence whose left (most significant) side consists of consecutive 1s, and its right (less significant) side of consecutive 0s. No mixing of 1s and 0s can occur.
PAGE 8
Avanti 3015ip Installation Notes TVS Serv. IP Address [141.226.213. 65]. 18. Enter the required TVS Server IP address and press [#]. The next option displayed is Web Serv. IP Address [192.333.22.123]. 19. Enter the required Web Server IP address and press {NEXT}. 20. You are asked Exit this menu? 21. Press {YES} to enter the User Menu, or {NO} to go back to step 16. The display shows now TVS User DN [786] This is the extension number for this station. You can enter up to four digits. 22.
PAGE 9
Avanti 3015ip Installation Notes And, after a short delay: FTP Loading -> Done! Then: ST3015ip -> TVS App Built: Dec 10 2003 Then: Starting Data Link Connecting to System The Avanti 3015ip is now up and running.