Products Dishwasher User Manual

8
¾ Position Water Line And House Wiring
Position water supply line and house wiring on the
floor of the opening to avoid interference with base of
dishwasher and components under dishwasher.
¾ Insert Drain Hose Through Cabinet
Upright the dishwasher and position in front of the opening.
Insert drain hose into cabinet wall hole. If a power cord is
used, guide the end through a separate hole.
TIP: Position water line and house wiring on the floor to avoid
interference with base of dishwasher.
¾ Slide Dishwasher Partially Into Cabinet
Do not push against front panel with knees. Damage will occur.
• Slide dishwasher into the opening a few inches at a time.
• As you proceed, pull the drain hose through the opening
under the sink. Stop pushing when the dishwasher is a few
inches forward of adjacent cabinetry.
• Make sure drain hose is not kinked under the dishwasher
and there is no interference with the water line and wiring or
other component.
¾ Level Dishwasher
IMPORTANT: Dishwasher must be level for proper dish rack
operation and wash performance.
• Place level on door and rack track inside the tub as
shown to check that the dishwasher is level.
• Level the dishwasher by adjusting the four leveling legs
individually.
• If adjustment to the right rear leveling leg is required,
loosen junction box bracket screw (through the access
hole) and rotate bracket clockwise.
TIP: Pull lower rack out, about halfway. Check to make sure
the rack does not roll forward or back into dishwasher. If the
rack rolls either direction, the dishwasher must be leveled
again.
• If door hits tub, the dishwasher is not installed correctly. Adjust leveling legs to align door to tub.