ICE MAKER/MAQUINA DE HACER HIELO INSTRUCTION MANUAL/MANUAL DE INSTRUCCIONES Model Number / No. de Modelo: PIM25SS BEFORE USE, PLEASE READ AND FOLLOW ALL SAFETY RULES AND OPERATING INSTRUCTIONS. La sección en español empieza en la página 15. Avanti has a policy of continuous improvement on its products and reserves the right to change materials and specifications without notice. Avanti Products, A Division of The Mackle Co., Inc. P.O. Box 520604 - Miami, Florida 33152 www.avantiproducts.
TABLE OF CONTENTS Ice-Maker Safety 3 Important Safeguides 4 Help Us Help You 5 Parts and Features 6 Important Safety Instructions 7 Installation Instructions 7 Before Using Your Appliance 7 Installation of Your Appliance 7 Electrical Connection 8 Operating Your Appliance 9 Control Panel Description 9 Operating Your Appliance 10 Getting Ice from Ice-bin 11 Care and Maintenance 11 Cleaning Your Appliance 11 Space Requirements 11 Power Failure 11 Troubleshooting Guide 12 Ser
ICE MAKER SAFETY YOUR SAFETY AND THE SAFETY OF OTHERS ARE VERY IMPORTANT. We have provided many important safety messages in this manual for your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to Potential hazards that can kill or injure you and others. All safety messages will follow the safety alert symbol And either the words” DANGER”, “WARNING” or “CAUTION”.
IMPORTANT SAFEGUIDES Before the appliance is used, it must be properly positioned and installed as described in this manual, so read the manual carefully. To reduce the risk of fire, electrical shock or injury when using the appliance, follow basic precaution, Including the following: • • • • • • • Plug into a grounded 3-prong outlet, do not remove grounding prong, do not use an adapter, and do not use an extension cord. It is recommended that a separate circuit, serving only your appliance be provided.
Help us help you… Write down the model and serial numbers. Read this guide carefully. You'll find them on a plate located on the rear wall of the ice maker. It is intended to help you operate and maintain your new ice maker properly. Please write these numbers here: Keep it handy to answer your questions.
PARTS AND FEATURES 1 2 3 4 5 6 7 8 9 10 11 12 13 14 Water tank Ice-bin Water tray Evaporator Insulated cabinet Fan motor Compressor Power socket Water pump Drain Carry handles Ice-bin with integrated handle Control panel Stainless steel cabinet 6
IMPORTANT SAFETY INSTRUCTIONS To reduce the risk of fire, electrical shock, or injury when using your ice maker, follow these basic precautions: WARNING • • • • • • • Read all instructions before using the ice maker. Danger or Warning: risk of child entrapment. Child entrapment and suffocation are not problems of the past. Junked or abandoned appliances are still dangerous. . . Even if they will “just sit in the garage a few days.” Before you throw away your ice maker: Remove the ice-bin.
Electrical connection WARNING IMPROPER USE OF THE GROUNDED PLUG CAN RESULT IN THE RISK OF ELECTRICAL SHOCK. IF THE POWER CORD IS DAMAGED, HAVE IT REPLACED BY AN AUTHORIZED AVANTI PRODUCTS SERVICE CENTER. • • • • • • • This ice maker should be properly grounded for your safety. The power cord of this ice maker is equipped with a three-prong plug which mates with standard three prong wall outlets to minimize the possibility of electrical shock.
OPERATING YOUR ICE MAKER Control Panel Description Start Press to start the ice making cycle. Stop Press to stop the ice making cycle. Ice Size ICE SIZE SELECTION of (S) small, (M) medium or (L) large. The default cube size from the factory is set at SMALL. Each time you press this button the cube size selection will change 1 size (Small, Medium, Large) in sequence. The chosen mode shall stay as selected unless changed or there is a power failure.
Operating Instructions Starting your Ice maker • Pull the ice bin forward and remove. • Remove any dust or objects that may be in the water tank • Using the water fill cup included with your unit, fill the water tank up to the area marked “MAX”: • • Select desired ice cube size by pressing the “ice size” selector (S, M and L). The ice-maker will automatically check the water level in the reservoir periodically.
Getting Ice from the Ice-bin • Pull the ice bin forward and remove. • Remove the amount of ice as desired and close by inserting the ice-bin back into the unit. CARE AND MAINTENANCE Caution Failure to unplug the ice maker could result in electrical shock or personal injury. • • • • • • • • • • Cleaning Your Ice Maker To ensure the cleanliness of the ice cubes, water in the reservoir should be replaced every 24 hours.
PROBLEMS WITH YOUR ICE MAKER? You can solve many common ice maker problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling the servicer. TROUBLESHOOTING GUIDE Problem Possible Cause Suggested Solutions The compressor works abnormally with a buzzing Noise. Water shortage indicator Light is on. The voltage is lower than recommended. Stop the ice maker and do not restart until the voltage is normal.
Service For Your Ice Maker We are proud of our customer service organization and the network of professional service technicians that provide service on your Avanti ice maker. With the purchase of your Avanti ice maker, you can be confident that if you ever need additional information or assistance, the Avanti Products Customer Service team will be here for you. Just call us toll-free.
YOUR AVANTI PRODUCTS WARRANTY Staple your sales receipt here. Proof of original purchase date is needed to obtain service under warranty. WHAT IS COVERED LIMITED ONE-YEAR WARRANTY LIMITED SECOND THROUGH FIFTH YEAR WARRANTY For one year from the date of purchase by the original owner, Avanti Products will, at its option, repair or replace any part of the unit, which proves to be defective in material or workmanship under normal use.
MEDIDAS DE PRECAUCION IMPORTANTES Para reducir el riesgo de un incendio, choque eléctrico o daños personales cuando use la máquina de hacer hielo, siga estas precauciones básicas. ADVERTENCIA • • • • • • • Lea todas las instrucciones antes de usar la máquina de hacer hielo. Peligro o Advertencia: riesgo de niños atrapados. Los niños atrapados o sofocados no so un problema del pasado. Electrodomésticos abandonados aun son peligrosos…aun cuando “solo estarán en el garaje un par de días”.
Conexión Eléctrica ADVERTENCIA EL USO INAPROPIADO DEL ENCHUFE A TIERRA PUEDE OCASIONAR RIESGO DE UN CHOQUE ELECTRICO. SI EL CORDON SE DAÑASE, LLEVELO A UN CENTRO DE SERVICIO AUTORIZADO POR AVANTI PRODUCTS PARA QUE SE REEMPLACE. • • • • • • • Para su seguridad, esta máquina de hacer hielo debe estar apropiadamente conectada a tierra.
OPERANDO SU MÁQUINA DE HACER HIELO Descripción del Panel de Control Start / Inicio Presione para iniciar el ciclo para hacer hielo. Stop / Parar Presione para detener el ciclo para hacer hielo. Ice Size / Tamaño del hielo SELECCIÓN DE TAMAÑO DEL HIELO hay tres tamaños: (S) pequeño, (M) mediano o (L) grande. El tamaño pre-programado en la fabrica es S (pequeño). Cada vez que presione el botón de selección de tamaño del hielo, el tamaño aumentara en progresión (Small, Médium, Large).
Instrucciones de Operación Iniciando el proceso con su máquina de hacer hielo • • Hale el contenedor de hielo hacia ud. y retírelo. Remueva el polvo o cualquier objeto que esté en el tanque de agua. • Utilice el recipiente que incluímos con la unidad para llenar el tanque de agua hasta el área marcada “MAX”. • Seleccione el tamaño del hielo deseado y presione el botón (S) pequeño, (M) mediano o (L) grande. La máquina de hacer hielo automáticamente verifica el nivel de agua en el tanque.
• • hacer hielo detendrá el funcionamiento y el indicador de ICE FULL (CICLO COMPLETO) se encenderá. Hay tres tamaños de cubos de hielo para su elección, por lo tanto, mientras más grande sea el tamaño deseado mas tiempo tomará el ciclo completo. Cuando la temperatura ambiente sea mas baja que 15°C (59ºF), se recomienda elegir cubos de hielo de tamaño S pequeño o M mediano ya que esto evitará que los cubos de hielo se peguen unos a otros.
• • • • • • Requerimientos de espacio El ángulo de inclinación de la unidad durante el transporte no debe exceder los 45° No ponga la máquina de hacer hielo de cabeza ya que esto puede producir problemas en el compresor y el sistema sellado. La máquina de hacer hielo debe ser colocada sobre una superficie correctamente nivelada. Para asegurar ventilación apropiada para su máquina de hacer hielo, deje 6” de espacio encima de la superficie, la parte posterior y los lados.
REGISTRATION INFORMATION Thank you for purchasing this fine Avanti product. Please fill out this form and return it within 100 days of purchase to receive these important benefits to the following address: Avanti Products, A Division of The Mackle Co., Inc. P.O. Box 520604 - Miami, Florida 33152 USA PROTECT YOUR PRODUCT: We will keep the model number and date of purchase of your new Avanti product on file to help you refer to this information in the event of an insurance claim such as fire or theft.
PRINTED IN CHINA 22