Specifications

PN SJ-IM-8AC
2-2
Operation
Summary of Avanti J-E Run Procedures
Programmed Run
1 Turn the POWER switch on (I).
2 Press DOOR to unlock the chamber door; lift the door open.
3 Install the rotor according to the applicable rotor manual, then close the chamber door and
press
DOOR.
4 Press PROGRAM, use the keypad to enter the required program number, then press ENTER. Press
SHOW SET to display program parameters.
5 Check that all parameters are correct and that the door is closed. Press ENTER, then press START
(within 5 seconds).
6 Wait for the run to end, or end the run by pressing STOP.
7 When the rotor stops (a tone sounds), press DOOR to unlock the chamber door; lift the door
open to remove the rotor.
Manual Run
1 Turn the POWER switch on (i).
2 Press DOOR to unlock the chamber door; lift the door open.
3 Install the rotor according to the applicable rotor manual, then close the chamber door and
press
DOOR.
4 Press ROTOR, then use the keypad to enter the rotor entry code.
5 Press RPM/RCF, then use the keypad to enter the run speed (300 to 21 000 rpm). Press RPM/RCF
a second time to enter speed in RCF.