Specifications

PN SJ-IM-8AC
2-7
Operation
Manual Operation
2
2 Use the keypad to enter required temperature.
Entered temperature appears on the display.
(If the entered temperature is lower than can be achieved for the installed rotor, a message
showing “
Input error temp” will be displayed.)
3 Press the next run-parameter key or ENTER.
Entering Acceleration and Deceleration Rates
The instrument provides a choice of two acceleration rates and three deceleration rates to protect
the gradient and sample-to-gradient interface. The acceleration time is the time it takes a rotor to
reach set speed from rest. The deceleration time is the time it takes a rotor to decelerate from set
speed to rest.
1 Press ACCEL.
Acceleration options are displayed.
2 Press the keypad number for the required acceleration rate — 1 = MAX, 2 = SLOW.
Entered acceleration rate appears on the display.
3 Press the next run-parameter key or ENTER.
4 Press DECEL.
Deceleration options are displayed.
5 Press the keypad number for the required deceleration rate — 1 = MAX; 2 = SLOW; 3 = OFF.
Entered deceleration rate appears on the display.