Specifications

PN SJ-IM-8AC
2-8
Operation
Programmed Operation
Starting a Run
1 Press ENTER and START.
The green light next to the
START key flashes and the rotor begins to spin.
NOTE To begin a run, ENTER must always be the last key pressed before pressing START. If you wait
more than 5 seconds, the START key will not activate. If this happens, press ENTER and START
again to begin the run.
If an unacceptable value was entered, the run will not begin when ENTER and START are
pressed.
a. Check the display and make any necessary corrections or additions.
b. Press
ENTER and START again to begin the run.
The run will end when the time display counts down to zero.
c. Press
STOP to terminate a run for any reason.
The green light next to the
STOP key will flash while the rotor decelerates.
A tone sounds when the rotor comes to a complete stop.
2 After the rotor has stopped, press DOOR.
The door is unlocked.
3 Remove the rotor.
Keep the chamber door closed between runs.
Programmed Operation
The instrument internal memory can store up to nine programs which can be recalled by keypad
numbers 1 through 9. Saved programs are retained in memory even if the power is turned off.
Procedures for entering run parameters are the same for programmed operation as those described
above for manual operation.
Creating a New Program
1 Press PROGRAM.
Previously saved program numbers are displayed.