Specifications

PN SJ-IM-8AC
2-9
Operation
Programmed Operation
2
2 Use the keypad to select a program number that is not in use or one that you want to overwrite
and press
ENTER.
The message “
Press ENTER START to run, or edit parameters” is displayed.
3 Enter run parameters (speed, time, temperature, acceleration/deceleration rate settings).
If you entered an unacceptable parameter, an error message will be displayed.
a. Press
CE and enter an acceptable value, then press the next run-parameter key.
4 When all parameters are entered, press SAVE.
The program is saved into memory.
NOTE
Record the program parameters on the Program Library record (233679).
5 Press ENTER START to run the programmed run (or press PROGRAM to exit program mode and
return to manual operation).
Starting a Programmed Run
1 Press PROGRAM.
Previously saved program numbers are displayed.
2 Use the keypad to enter the number of the program, then press ENTER.
The message “
Press ENTER START to run, or edit parameters” is displayed.
3 Press SHOW SET.
The number you selected will appear in the program display.
Run parameters for that program will be displayed for 5 seconds.
(To make changes, see Changing a Program, below.)
4 Press ENTER and START to begin the programmed run (or press PROGRAM to exit program mode
and return to manual operation).
The run starts, the green light next to the
START key flashes, and the rotor begins to spin.
NOTE
To begin a run, ENTER must always be the last key pressed before pressing START. If you wait
more than 5 seconds, the START key will not activate. If this happens, press ENTER and START again
to begin the run.