Specifications

PN SJ-IM-8AC
2-10
Operation
Programmed Operation
If an unacceptable value was entered, the run will not begin when ENTER and START are
pressed.
a. Check each display and make any necessary corrections or additions.
b. Press
ENTER and START again to begin the run.
The run will end automatically when the time display counts down to zero.
c. Press
STOP to terminate a run at any time.
The green light next to the
STOP key will flash while the rotor decelerates.
A tone will sound when the rotor has come to a complete stop.
5 After the rotor has stopped, press DOOR.
The door is unlocked.
6 Remove the rotor. Keep the chamber door closed between runs.
Recalling and Changing a Program
Recalling a Program
A program that has been saved in memory can be recalled at any time.
1 Press PROGRAM.
Previously saved program numbers in use are displayed.
2 Select the appropriate keypad number and press ENTER.
The message “
Press ENTER START to run, or edit parameters” is displayed.
3 Press SHOW SET to display program parameters.
4 To begin the run, press ENTER and START.
The run starts.