User`s manual

30
AVANTI Service Lift for Wind Turbines
Fig. 18 Wire diameter
Fig. 19
Wire strap/loop,
which cannot be
unwound
Loop knot forming
when a wire loop is
pulled tight
Bends resulting from
inappropriate treatment
(e.g. securing the load
with the wire)
Damage resulting from
crushing, squeezing,
running over, etc.
Wire bags
Loop formation
12.1.5 Overload limiter/information signs
Annual test:
Test switches as specified in section 5.3 and 5.4 of
the User’s Manual.
Perform overload test as specified on page 54 of
the Installation Guide.
Verify completeness and legibility of all rating
plates and information signs. Replace missing or
illegible plates and signs!
12.2 Repairs
Repairs to traction hoist equipment may ONLY be
performed by the manufacturer or a hoist service
centre, and only using original spare parts.
If the gearbox oil needs to be replaced, use one of
the lubricants specified in the following table,
corresponding to the temperature range in which
the traction hoist equipment is used.
Amount required:
traction hoist X402P: 1.4 l.
traction hoist L502P: 1.4 l.
traction hoist M500: 1.4 l.
See table 4.
Table 4
Fig. 20
X402/L502
M500
Temperature
range
-15ºC to 80ºC -35ºC to 40ºC
Synthetic oil
API specification
CLPPG or CLPPG or
PGLP ISO VG 460
1)
PGLP ISO VG 100
Oil specification
Klübersynth
GH6 460
Klübersynth
GH6 100
1)
Standard filling
Use of other synthetic oil only with
approval by AVANTI.