User`s manual

STOP

Installation Manual

Please familiarise yourself with these instructions and the User Manual (Model SHARK) before

installing the service lift. Ensure that all speciﬁed parts are present before commencing installation.

No warranty is provided against damage and injury resulting from not following this “User’s Manual and

Installation Manual” i.e. reconstruction or modiﬁcation of equipment or use of non-original parts which are

not approved by the manufacturer.

Assemble the SHARK service lift close to its ﬁnal

place of installation. Assemble both versions,

sliding doors and double doors, as follows:

Installation holes have been pre-drilled. Bolts, nuts

etc can be found in the plastic bags supplied.

1. Assemble the right, left and bottoms sections

with the cabin resting on its back.

2. Mount the roof spine and then slide the roof

into position and ﬁt to the cabin.

3. Fit the wire guides.

4. Mount the traction hoist and safety brake to the

spine.

5. Attach the cabin front.

6. Mount the 4 bottom rubber feet to the bottom

of the cabin.

7. Mount the operation limit stop switch and

emergency limit stop switch on the roof using

the contact bracket.

8. Attach the bottom safety stop beam including

the wires that hold the bottom safety stop

beam.

9. Bring the cabin to its upright position.

10. Mount the doors on the cabin. On the Double

door version - remember to install the ground

wire at the top hinge.

11. Mount the steps and handle inside the cabin.

12. Feed the power cable through the rear hole

and ﬁt the socket to the back using the strips.

13. Mount the bottom safety stop switch and

adjust. Connect the switch cables to the power

cabinet according to the colour code. All wires

are secured using strips (max 200mm between

strips).

All bolts and nuts are stainless steel.

DANGER!

If it is possible to enter underneath the

service lift a double button safety stop

must be ﬁtted. (See Installation Manual

pages 34-36).

1. Assembling the SHARK cabin