User`s manual

55
Installation Manual
CAUTION!
Wear protective gloves
when handling wires.
2.5.1 Drive wire installation
a) Remove protection guard above rollers
b) Feed the wire through the roof into the traction
hoist’s wire inlet opening. (Right side seen from
front of lift).
c) Push the UP button on the pendant control
and feed wire through until the traction hoist
starts pulling. Ensure that the wire can exit
without obstruction!
d) Continue feeding the wire underneath (round)
the front guide wheel, over the back guide
wheel, and through the back panel.
e) Let the lift wire pass through until it is slightly
tightened.
f) Replace roller protection guard.
g) Feed wire through platform floor.
2.5.2 Safety wire installation
a) Remove protection guard above rollers.
b) Open the safety brake gripping device by
pushing down the lever until it engages/clicks
(Fig. 16 Appendix A). Feed the safety wire
through the roof hole above the safety brake
and continue by feeding through the safety
brake.
c) Like the lifting wire, continue feeding the wire
underneath (round) the front guide wheel, over
the back guide wheel, and through the back
panel.
d) On the back of the lift pull the safety wire to
tighten it.
e) Replace roller protection guard.
f) Feed wire through platform floor.
Fig. 12 Back side
Drive wire Safety wire
Ensure that the
wires can exit freely!
Drive wire contra
weight
Safety wire push
spring
ON/Locked
OFF/Open
Fig. 11
X402 / L502 M500
2.5 Installation of drive and safety wire in lift