User`s manual

58
!
!
AVANTI Service Lift for Wind Turbines
2.7 Wire fix alignment
Having mounted the service lift, the wires, and the
power, the wire fix fittings are adjusted during the
initial ascent.
a) Perform the tests prescribed in section 5 of the
User’s Manual (page 19).
b) Install wires as shown in Fig. 14.
By means of the oblong holes in the wire fix
fittings, adjust the fittings so that the two parts
pass each other easily, when the lift passes.
Fig. 14
Wire guide
Wire fix
Narrow wire guide
Clic-on wire fix
Standard wire guide
Clic-on wire guide
Bracket
platform
(optional)
CAUTION!
Wire fixe must be mounted on
guide wires on all platforms with max.
30 m between each wire fix.
ATTENTION!
During the first run make sure the power
cable untwists evenly.
ATTENTION!
If tripods are used for guide wire fixing
tighten the wire locking device after the
first run.
Roller wire guide