User's Guide

8
 Steps to replace water bottles
• Use a clean cloth to wipe off neck of bottle.
• Remove cap.
• Carefully lift bottle (approx. 40 lbs.) using your legs and not your back. Do not place hands on
opening of bottle while placing in reservoir.
• Insert the water bottle on the water intake over reservoir opening so it settles properly on it.
• Wipe off any water which may have splashed on dispenser top.
• When a new bottle is installed you must open the hot water faucet and remove no less than 4 full
cups of water to insure the water flows properly and the water reservoir is at the proper level.
 Hot and Cold Power ON/OFF Indicator Lights
Once the power switches for the HOT and COLD water systems (located on the rear of the unit) have
been turned ON, these lights will illuminate to advise the user that the systems are activated and
operating.
 Hot Water Indicator Light
Turn the heating switch on, the red indicator will glow and the heating process starts. When the water
reaches the right temperature (185º - 203ºF / 85º - 95ºC) the red light goes off automatically. When
the temperature goes below 176ºF (80ºC), the red indicator will glow again and another heating process
starts.
 Cold Water Indicator Light
Turn the cooling switch on. The blue indicator will glow and the cooling process will begin. When the
water reaches the right temperature (41º - 50ºF / 5º - 10ºC) the blue indicator light will turn off
automatically. Once the water temperature reaches above 50ºF (10ºC) the blue indicator light will glow
again indicating another cooling process has started.
To dispense hot water:
♦ Slide red safety button to the right and hold while pressing downward on hot water faucet to
dispense hot water.
♦ Safety button will return to its original position when faucet is released.
♦ Ensure all water has dispensed prior to removing glass from the dispensing area.
To dispense cold water:
♦ Press and hold downward on the cold water faucet to dispense cold water.
♦ When you have dispensed the desired amount of water, simply release the cold water faucet.
♦ Ensure all water has dispensed prior to removing glass from the dispensing area.
NOTE:
THE HOT WATER FAUCET HAS A CHILD-SAFETY GUARD ATTACHMENT.
WARNING
IMPROPER USE OF THE GROUNDED PLUG CAN RESULT IN THE RISK OF ELECTRICAL SHOCK. IF
THE POWER CORD IS DAMAGED, HAVE IT REPLACED BY AN AUTHORIZED AVANTI PRODUCTS
SERVICE CENTER.