User's Manual

Use only the correct charger as supplied with this device.

Replacement or service must be done by a qualified service center or by the

manufacturer.

Unplug this device when unused for long periods, or during lightning storms.

CAUTION: ELECTRIC SHOCK HAZARD

The battery in this device may present a risk of fire or chemical burning if

mistreated.

8. Declaration of Conformity

8.1. EU

This product is CE certified according to the provision of the R&TTE Directive

(1999/5/EC). We declare that this product is in compliance with the essential

requirements and other relevant provisions of Directive 1999/5/EC.

8.2. FCC Statement

1). This device complies with Part 15 of the FCC Rules. Operation is subject

to the following two conditions:

• This device may not cause harmful interference. and

• This device must accept any interference received, including interference

that may cause undesired operation.

2). Changes or modifications not expressly approved by the party responsible

for compliance could void the user's authority to operate the equipment.

8.3. RF Warning Statement

The device has been evaluated to meet general RF exposure requirement.

The device can be used in portable exposure condition without restriction.

NOTE: This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful interference

in a residential installation. This equipment generates, uses and can radiate

radiofrequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation.

If this equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following

measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

Consult the dealer or an experienced radio/TV technician for help