User's Guide

Installation and commissioning procedures 6-17
User guide NTXXXXXX Rel 3.0 Draft October 2000
Procedure 6-4
Setting up the Internet BWA System 3200
Use this procedure to set up and align the Internet BWA System 3200.
On start-up, the Internet BWA System 3200 loads its operating software from
its flash memory. During initialization, the radio remains mute until it
completes its self-diagnostic tests.
After start-up, you can monitor and control the Internet BWA System 3200
with the use of the hand-held terminal (HHT).
Requirements
Required equipment:
• RG-58 coaxial cable or HHT-to-ODU whip antennas
• HHT
Action
Step Action
1 Apply DC power to the radio.
Initialize the HHT
2 Stand within 75 meters of the Internet BWA System 3200
3 Press and hold the ENTER key of the HHT until the display lights up.
The HHT default display appears and reads:
Enter ODU Addr:
Enter the near-end terminal address
4 Use the keypad to enter the Internet BWA System 3200 address (the ODU
serial number).
5 Press the ENTER key.
The HHT displays the message:
Establishing Link
When you establish communication between the HHT and the Internet BWA
System 3200, the Near Radio menu appears on the display.
6
—continued—
If Then
you cannot establish communication between
the HHT and the Internet BWA System 3200
go to step 7
otherwise go to step 8