User's Guide

Installation and commissioning procedures 6-19
User guide NTXXXXXX Rel 3.0 Draft October 2000
Procedure 6-4 (continued)
Setting up the Internet BWA System 3200
Step Action
12 To change the Set Pwr setting,
a. Use the keypad to enter the required transmit RF power output (Range
+2 to +17 dBm). For example, to insert 2dBm, enter:
Set Pwr: 2dBm
b. press the ENTER key.
13 Press the MENU key to return to the Control menu.
14 Press the MENU key again to return to the Far End menu.
Verify and set the link ID
Use the following steps to establish link identification when multiple Radio
links are located at the same site.
Use the following steps to set the near-end and far-end terminals to the same
Link ID number.
15 Go to the Near End | Control menu.
The following message appears on the display:
Set TX
16 Press the ARROW key until the Set Link ID (FAW) command appears on the
display.
17 Press the ENTER key.
The current setting appears on the display.
18 To change the Set Link ID (FAW) setting:
a. Use the keypad to enter an ID number (Input range 0-7).
b. Press the ENTER key.
19 Press the MENU key to return to the Control menu.
20 Press the MENU key again to return to the Near End menu.
21 Repeat step 15 to step 20 for the far-end terminal to make sure that both
terminals have the same “Link ID” number.
—end—