User's Manual

Administering and setting up video H.323 endpoints
Administering Avaya Video Conferencing Solution 6.0.1 Issue 2.1 April 15, 2011 81
Creating a Route Pattern for the Video Trunk
To create a route pattern that points to the trunk group, enter change route-pattern n
(where n is the route pattern you want to use) and set the following parameters:
● Grp No : enter the number of the trunk group you created.
Avaya one-X
®
Communicator
Avaya one-X
®
Portal integration and video calls feature are installed by default. However, these
are not enabled. You can enable these features by modifying the settings after installation. See
Avaya one-X
®
Communicator getting started for instructions to download and install the
software.
Configuring a Station Endpoint for Avaya one-X
®
Communicator with H.323
Avaya one-X
®
Communicator can use either the H.323 or SIP protocol. When an Installation
Engineer installs Avaya one-X
®
Communicator, they make the choice between H.323 and SIP.
This section describes how to enable video calls for a desktop user using the H.323 protocol.
Before you begin, it is important to verify that you have valid licenses for Avaya one-X
®
Communicator.
Video is an optional feature in Avaya one-X
®
Communicator. In addition, Users must install
Avaya one-X
®
Communicator on their PCs before they can handle video calls from their
desktops.
Checklist
When setting up video calls for a desktop, you will need to know the following information:
● the station number of the desktop user
● the IP codec sets you want to use
● the IP network regions you want use
Determining the Maximum Number of Video-Capable Endpoints Supported
To determine the maximum number of video-capable endpoints your voice system supports,
enter display system-parameters customer-options and verify the Maximum Video
Capable IP Softphones. This number is provided by the license file.