User's Manual

Administering video endpoints
90 Administering Avaya Video Conferencing Solution 6.1 Issue 1
DRAFT
● SIP Registrar : Enabled
● Registrar Hostname : Same as Proxy Hostname
● TCP : Enabled
● TCP signaling port : 5060
4. To confirm or verify if user registration is complete, under Communication click SIP and
ensure the following.
● Registrar Status : Registered
5. To configure the AVCS 1000 series endpoints using a web browser, enter the IP address of
the endpoint in the address bar and follow the steps as shown above.
Adding an audio call to Avaya 1010/20/30 video endpoints
1. Log on to the video endpoint. The default password is 1234. Click the blue System Menu
Button on the remote. Select Admin Preferences by using the arrow buttons.
2. Navigate to System Menu > Administrator Preferences > Communications > General
and enable Multiway calls.
3. Set Call Appr as shown in
Administering call routing on page 63.
Avaya Virtual Link
Avaya VirtualLink allows Avaya 1010/1020 to share IP-based presentation data during a call.
For Installation procedures and system requirements, see Avaya Virtual Link installation Guide.
Note:
Note: Avaya VirtualLink and Avaya 1010/1020 must be in the same LAN, or the
computer running Avaya VirtualLink must be connected to the network through
VPN. Avaya VirtualLink does not process requests through NAT or firewall
traversal.
Prerequisites
● Avaya 1010/1020 must be running version 4.7 or later. System software upgrades are
available to licensed users at
http://support.avaya.com. Refer to the Avaya 1010/1020
User Guide for upgrade instructions.