Application Note

ManualsBrandsAvaya ManualsIP DeskphonesAvaya 1100- and 1200-Series IP Deskphones R3.2

FS; Reviewed:

SPOC 09/07/2010

Solution & Interoperability Test Lab Application Notes

13 of 44

11xx12xx-SM

5.8. Define the Dial Plan

This section describes the steps for administering the dial plan, including overall dial plan

format, Feature Access Codes (FACs), and Feature Name Extensions (FNEs).

Step Description

Use the change dialplan analysis command to define the dial plan formats used in the

system. This includes all telephone extensions, Feature Name Extensions (FNEs), and

Feature Access Codes (FACs). To define the FNEs for the features listed in Table 2, a

Feature Access Code (FAC) must also be specified for the corresponding feature. In the

sample configuration, telephone extensions are five digits long and begin with 3, FNEs

are five digits beginning with 7, and the FACs have formats as indicated with Call Type

“fac”. Note: a FAC of “8” was used for AAR routing by a voice mail hunt group, the

configuration for which is not included in these Application Notes. See Reference [11]

for more information.

change dialplan analysis Page 1 of 12

DIAL PLAN ANALYSIS TABLE

Location: all Percent Full: 2

Dialed Total Call Dialed Total Call Dialed Total Call

String Length Type String Length Type String Length Type

0 3 fac

1 3 dac

2 5 ext

3 5 ext

4 5 ext

5 5 ext

6 3 fac

7 5 ext

8 1 fac

9 1 fac

* 2 fac

# 2 fac

Use the change private-numbering command to add an entry as shown below for the

calling extensions that will be using the trunk to Session Manager. The entry specifies the

format that the calling number will have in outgoing calls. Set Ext Len to the length of

the calling extensions, Ext Code to an initial set of digits that covers the extension range,

Trk Grp(s) to the trunk group number defined in Section 5.6, and Total Len to the

length of the calling extensions. In the sample configuration, the extension is sent

unchanged. Note: if the Trk Grp(s) field is left blank, as in the first entry, this formatting

will be applied to all trunk groups in the system.

change private-numbering 0 Page 1 of 2

NUMBERING - PRIVATE FORMAT

Ext Ext Trk Private Total

Len Code Grp(s) Prefix Len

5 2 5 Total Administered: 3

5 3 60 5 Maximum Entries: 540

5 4 60 5