User Guide

Incoming call while dialing outbound number + held call with priority lower then
incoming call
When you enter the first digit or character to make a new call, then any call that comes in during
this time is not presented.
If the held call is lower in precedence than the incoming call, the held call can be preempted
and a notification is shown on screen for both local and remote users. You receive notification
that the your held call has been preempted.
After three seconds, or after you press the OK soft key on the preemption screen, you are
taken back to the previous screen where you were entering the address for your outgoing call.
Your previously entered digits are not discarded.
This temporary disturbance is allowed because the held call was known to you and you need
to know that the call on hold has been preempted.
The incoming call that preempted the held call is shown when:
• you complete dialing the call and a ring or busy signal is heard. It may be possible that
the outgoing call can be preempted but only after ring or busy signal is heard. The
incoming call is presented if the incoming call has not hung up. You can decide to answer
the new incoming call
• you decide to cancel dialing and the IP Deskphone goes back to the idle screen again.
This allows the incoming call to be presented if the incoming call has not hung up. You
can decide to answer the new incoming call.
Re-authorization
While you are logged in to your IP Deskphone, the administrator may change your password.
Consequently, any call or network request placed by you is responded to with an error
message.
When the Re-authorization feature is enabled, your password is changed by the administrator,
and you are trying to place a call, you can enter your new password, when prompted, without
having to log out of your IP Deskphone.
If you enter the new password correctly, the call is placed and your password is updated on
the IP Deskphone.
If you enter an incorrect password, then an error message is displayed, you hear a busy tone,
and the IP Deskphone returns to the idle state.
Feature interactions with MLPP
The following table lists feature interactions with MLPP.
Advanced features
190 Avaya 1120E IP Deskphone with SIP Software on Avaya Aura
®
User Guide November 2013
Comments? [e-mail]