User guide

Using your IP Phone 1120E
43
Method A:
1. Press the wall-mount lever, and pull the phone away from the stand,
as shown in the following figure.
2. Use the stand cover (the part you removed in “Removing the stand
cover” on page 39), to mark the wall-mount holes by pressing the
bottom of the stand cover firmly against the wall in the location where
you wish to install the phone. Four small pins on the bottom of the
stand cover make marks on the wall.
3. Use the marks as a guideline for installing the wall-mount screws (not
provided). Install the screws so that they protrude 3 millimeters (mm)
(1/8 inch) from the wall.I
4. Install the phone stand mounting holes over the screw heads as
indicated in Figure 9 on page 42 (Method A). You may need to
remove the phone from the wall to adjust the lower screws.
5. When the lower screws are snug, install the phone on the mounting
screws, and then tighten the top screws.
Figure 10: Rotate the phone into the wall mount position.
Tilt lever Wall-mount lever