User guide

Using your IP Phone 1120E
44
Method B:
1. Attach the 15-cm (6-inch) CAT5e cable.
2. Position the stand over the mounting rivets, and slide the phone down
the wall so that the rivets fit into the slots on the stand, indicated in
Figure 9 on page 42 (Method B).
3. Replace the stand cover. Ensure that all cables are neatly routed and
press the stand cover into place until you hear a click.
4. Put the phone in the wall-mount position (optional). If you wall-mount
your phone, put it in the wall-mount position by holding the Tilt Lever
and pressing the phone towards the base until the phone is parallel
with the base. Release the Tilt Lever and continue to push the phone
towards the base until you hear an audible click. Ensure the phone is
securely locked in position.
Attention: To add an IP Phone 1100 Series Expansion Module see,
Expansion Module for IP Phone 1100 Series (SIP Firmware) User
Guide (NN43110-301).
Entering text
You can enter and edit text on your IP Phone 1120E using the following
methods:
• “Entering text using the telephone dialpad” on page 45
• “Entering text using the USB keyboard” on page 50
You can make a call by dialing a telephone number (Directory Number) or
by dialing a person’s alphanumeric SIP address (for example,
[e-mail]).
Attention: Some service providers only support the use of a
Directory Number (DN) such as 555-5555 to initiate a call to another
phone. Contact your system administrator or service provider to
determine if alphanumeric dialing is supported.
Alphanumeric dialing refers to the spelling of names or words by dialing
alphabetic characters which are located with the numbers on the numeric
dialpad of your IP Phone 1120E. You can use an Alphanumeric entry