User guide

Connecting the components

Figure 5: Remove the stand cover

2. Connect the AC power adapter (optional). Connect the adapter to the

AC adapter jack in the bottom of the phone. Form a small bend in the

cable, and then thread the adapter cord through the channels in the

stand.

Warning: Use your IP Phone 1120E with the approved Nortel AC

Adapter (model #N0023000) for this model of phone only.

Note 1: Your IP Phone 1120E supports both AC power and Power

over Ethernet options, including IEEE 802.3af standard power. To

use local AC power, the optional AC adapter can be ordered

separately. To use Power over Ethernet, where power is delivered

over the CAT-5 cable, the LAN must support Power over Ethernet,

and an AC adapter is not required.

Note 2: You must use CAT-5e (or later) cables if you want to use

gigabit Ethernet.

Tilt Lever

Button

Center

Catch

Handset

cord exit