User guide

3. Use the marks as a guideline for installing the wall-mount screws (not provided).
Install the screws so that they protrude 3 millimeters (mm) (1/8 inch) from the
wall.
4. Install the IP Deskphone stand mounting holes over the screw heads as indicated
in the following figure — Method A. You need to remove the IP Deskphone from the
wall to adjust the lower screws.
5. When the lower screws are snug, install the IP Deskphone on the mounting screws,
and then tighten the top screws.
Figure 10: Cable routing tracks and mounting holes
Method B:
1. Attach the 15-cm (6-inch) CAT5e cable.
2. Position the stand over the mounting rivets, and slide the IP Deskphone down the
wall so that the rivets fit into the slots on the stand, indicated in the preceding figure
— Method B.
3. Replace the stand cover. Ensure that all cables are neatly routed and press the
stand cover into place until you hear a click.
4. Put the IP Deskphone in the wall-mount position (optional). If you wall-mount your
IP Deskphone, put it in the wall-mount position by holding the Tilt Lever and pressing
the IP Deskphone towards the base until the IP Deskphone is parallel with the base.
Release the Tilt Lever and continue to push the IP Deskphone towards the base
Installing the 1140E IP Deskphone
58 Avaya 1140E IP Deskphone with SIP Software on Avaya Aura
®
User Guide November 2013
Comments? [e-mail]