User guide

Setup and assembly

1. Press the tilt lever to adjust the stand angle on the IP Deskphone.

You can adjust the stand angle to maximum, instead of removing the

stand. See Figure 3.

Figure 3: Adjusting the stand angle on the IP Deskphone

2. At the back of the IP Deskphone, remove the rubber plug from the

AEM port. Place the connecting arm of the Expansion Module behind

the IP Deskphone and align the Expansion Module connection plug to

the AEM port on the back of the IP Deskphone.

3. Insert the screws in to the top and bottom holes of the connecting arm of the

Expansion Module and tighten until snug. See Figure 4 on page 17.

Wheel

Accessory Expansion Module (AEM) Port

Tilt

Lever

Clamp