Application Note

TBH; Reviewed:
SPOC 9/16/2014
Solution & Interoperability Test Lab Application Notes
©2014 Avaya Inc. All Rights Reserved.
9 of 11
JabraMO_L351600
7. Jabra Motion Office Configuration
Jabra Motion Office should be configured to use DHSG protocol and the clear dial-tone switch
should be set to position “A”. There are two modes of configuring the desk phone settings,
guided or manual. For compliance testing, the manual mode was used. Use the following steps
to manually configure Jabra Motion Office:
 Select the tool icon on the top right hand corner of the headset touch screen
 Select phone settings
 Select desk phone
 Select setup desk phone
 Acknowledge the warning message given by selecting confirm
 Select manual desk phone setup
 Select DHSG adapter type
 Under set clear dial-tone switch select position “A”
 Select a microphone level
 The base will restart after exiting to apply the settings
8. 1600 Series IP Deskphone Settings
To set the default audio path for 1600 Series IP Deskphones select Menu Call Settings 
Audio Path and then select Headset.
9. Verification Steps
Verify that the Jabra LINK 35 and Jabra Motion Office have been connected to the Avaya 1600
Series IP Deskphone correctly. Once the headset is connected to the phone, verify that incoming
and outgoing calls are established with two-way audio to the headset and that the headset can get
dial tone and end an active call.
10. Conclusion
These Application Notes describe the configuration steps required to integrate Jabra LINK 35
EHS Adapter and Jabra Motion Office with Avaya 1600 Series IP Deskphones. All test cases
were completed successfully.