User's Manual

Local Administrative Options
18 1600 Series IP Deskphone Installation and Maintenance Guide
Disable/Enable Event Logging
Use the following procedure to enable or disable logging of system events.
1. While the deskphone is on-hook and idle, press the following sequence of keys on the faceplate of
the deskphone:
Mute 5 6 4 # (Mute L O G #)
Note:
Note: Press the Mute button momentarily. Do not press this button while pressing other keys/
buttons.
2. After entry of the command sequence, the deskphone displays the following text, depending on the
current value of the system parameter NVLOGSTAT:
where status is the type of logging indicated by the NVLOGSTAT value, defined as:
● Status is disabled when NVLOGSTAT = 0
● Status is emergencies when NVLOGSTAT = 1
● Status is alerts when NVLOGSTAT = 2
● Status is critical when NVLOGSTAT = 3
● Status is errors when NVLOGSTAT = 4
● Status is warnings when NVLOGSTAT = 5
● Status is notices when NVLOGSTAT = 6
● Status is information when NVLOGSTAT = 7
● Status is debug when NVLOGSTAT = 8
3. To change the logging status, press *.
Depending on the current value, the next sequential valid NVLOGSTAT value is selected and
displayed as the status. For example, if the current value is alerts (2), pressing * changes the value
to 3 (critical). If the current value is debug (8), pressing * changes the value to 0 (disabled).
If a value different from the current NVLOGSTAT value is entered, the following text displays
left-justified at the top of the display:
Log=status
*=change #=OK
Save new value?
*=no #=yes