User's Manual

Scenarios for the Restart Process
Issue 1 January 2008 55
6. When control is passed to the software that was just loaded, the following messages
display:
This message continues while the new boot code is being written into RAM.
!
Important:
Important: Pressing Program at this time invokes the Craft Access entry procedure to allow
manual settings, but only if the PROCSTAT (local dialpad procedure status)
system value is “0” providing full access to local procedures or when PROCSTAT
is “1” in certain situations requiring input. For information, see Chapter 3:
Local
Administrative Options.
7. The telephone displays the speed of the Ethernet interface in Mbps, that is, 0, 10, or 100.
The message No Ethernet displays until the software determines the interface speed.
Note:
Note: The Ethernet speed indicated is the LAN interface speed for both the telephone
and any attached PC, assuming the administrator has not disabled the latter
interface by a PHY2STAT setting.
8. The IP telephone sends a request to the DHCP server and invokes the DHCP process.
The following message displays:
where s is the number of seconds that have elapsed since DHCP was invoked. The number
of elapsed seconds is incremented once per second, until DHCP successfully completes.
9. VLAN verification and tagging occur. The following message displays:
where n is the VLAN ID being used.
10. The DHCP server provides IP Addresses for the following hardware:
● The IP telephone
● The HTTP/HTTPS server
● The SIP Proxy server
Starting...
Updating boot code...
DO NOT UNPLUG THE PHONE!
DHCP: s secs
VLAN ID = n