User's Manual

SZ; Reviewed:
SPOC 8/10/2007
Solution & Interoperability Test Lab Application Notes
©2007 Avaya Inc. All Rights Reserved.
15 of 30
ACM-Cisco-CM-GK.doc
Use the command change private-numbering to change private format for the calling number.
The configuration below will use the phone extension as the calling number.
change private-numbering Page 1 of 1
NUMBERING - PRIVATE FORMAT
Network Level: 0 PBX Identifier:
Level 2 Code: Deleted Digits: 0
Level 1 Code:
The command save translation must be entered to save the administration performed.
4. Cisco 2811 Gatekeeper and Cisco CallManager
Configuration
4.1. Configuring the Cisco 2811 Gatekeeper
The following are the annotated Cisco 2811 Gatekeeper configuration. A Gatekeeper will
forward the LRQ from Avaya CM and Cisco CallManager when the LRQ forwarding is enabled
on the GK. To enable a gatekeeper to forward LRQ messages, use the lrq forward-queries
command in gatekeeper configuration mode. Note that lrq forward-queries add-hop-count
must be configured on the Cisco 2811 GK, to allow the Cisco 2811 GK to forward the LRQ from
Avaya Communication Manager.
There is one local zone named GateKeeper and one remote zone named G350 configured on the
Cisco 2811 GK. Zone prefix “61*” (where * will match any sequence of numbers following 61)
is associated with the Cisco CallManager telephone extensions, and the Zone prefix “45*” is
associated with the extensions configured on Avaya Communication Manager.
For bandwidth control, the maximum bandwidth allowed between the local and remote zones is
configured as 256 kb. If the maximum bandwidth is fully utilized, the GK will reject any
additional call attempts.