Release Notes

BCM 3.6 and SRG 1.0 Wireless IP Telephony Patch
Page 11 of 14
initial release. At the next BCM release they will be included as part of the online BCM
core documentation:
BCM Wireless LAN IP Telephony Installation & Configuration Guide
BCM Wireless LAN Handset 2210/2211 User Guide.
5. 2210/2211 limitations
• i2210/i2211 jitter buffer size cannot be adjusted. Any changes in unified manager
will not be enforced by the handset.
• i2210/i2211 does not support RTCP
• i2210/i2211 does not support G.723 codec
• i2210/i2211 can upgrade firmware only through TFTP server
• i2210/i2211 does not support services key
• i2210/i2211 does not support paging and voice call
6. Known issues
• Dash appears in extension (“Ext.” when the handset is in standby mode) digit
string after the fourth digit (Q00940611)
• 22xx sets when "Charge Completed" seen on LCD cannot make call until the
melody stops (Q00960559)
• Letters Q and Z missing from numeric key pad (Q00946372)
• i2210 & i2211 DNs not seen in UM DN Registration>IP Wireless DN's reg'd –
instead they are found under DN Registration>IP Set DN reg’d (Q00951225)
• 2210 and 2211 will appear as i2004 in Unified Manager under
Services>Telephony Services>Telephony Services>System DNs>Active Set
DNs>DN xxxx>General>Model
• i2210/i2211 handsets will appear as i2004 in the Unified Manager under
Services>IP Telephony>> IP Terminals>Nortel IP Terminals when ‘offline’
• Group Listen feature (F802) activated on i2210 & i2211 shows "Pick up Handset"
on the screen (Q00940283)
• i2211 & i2210 cannot scroll when using Feature * 900( Q00940234)
• i2211 & i2210 F*7 does not do anything to LCD Display (Q00940265)
• i2211 & i2210 can access Set-Based Administration but cannot navigate menus
(Q00940267)
• When the WLAN Application Gateway 2246 has been deployed in a BCM/SRG
network, the built-in BCM/SRG DHCP Server cannot be used to assign IP
addresses to the WLAN Handsets 2210 and 2211. For this scenario, the two
alternatives available are as follows:
o Configure the WLAN Handsets 2210 and 2211 using static IP addresses
o Deploy a 3rd party DHCP Server
• In rare instances, the message "Speed or Duplex mismatch error" may occur
during the boot-up sequence of the IP Telephony Manager 2245. Workaround: If
this situation occurs, complete the following steps: