Release Notes

BCM 3.6 and SRG 1.0 Wireless IP Telephony Patch
Page 3 of 14
Executive Summary
In general, the objective of BCM 3.6/SRG 1.0 WLAN IP Telephony patch is to provide
Unified Manager and DHCP Server support for Wireless IP Handset 2210 and 2211. This
patch will be rolled into the factory build as at the next BCM release, BCM 3.7.
This document contains release notes that describe the new behaviors introduced by
BCM 3.6/SRG 1.0 WLAN IP Telephony patch as well as the limitations that apply to the
proposed solution. It is not an up-issue of the BCM 3.6 release. For the known issues of
BCM 3.6 GA release, please refer to the BCM 3.6 GA release notes document.
Notice
If the BCM Cumulative Patch 1.0 must be applied, it is recommended
to apply it first then apply the WLAN IP Telephony patch.
Behavior Changes
Wireless LAN IP Handsets 2210 and 2211 will be reflected as i2210 and i2211 set types
in Unified Manager’s ‘IP Terminal Status’ table and BCM Monitor vs. i2004 without the
patch.
The DHCP Server configuration page in Unified Manager provides two new fields
reserved for specifying the TFTP server and SVP IP addresses required by the 2210/2211
handsets.
Required Components
In order to access the WLAN IP Telephony capability on a BCM/SRG, the following
components are required:
• A BCM with version 3.6 Build 2.2C (GA version of BCM 3.6) or higher with the
BCM 3.6/SRG 1.0 WLAN IP Telephony patch applied (BCM Patch #38).
• 2210 and 2211 running f/w version 97.037
• 2245 running f/w load 2.007
• Spectralink-approved Wireless Access Point (see appendix 1)
• IP Client key codes applied
Software location
• 2210 firmware for SRG: Go to http://www130.nortelnetworks.com/cgi-
bin/eserv/cs/main.jsp .
In box 1, select Succession->Succession Enterprise
In box 2, select WLAN Handset 2210
In box 3, select Software
Hit Go.
• 2211 firmware for SRG: Go to http://www130.nortelnetworks.com/cgi-
bin/eserv/cs/main.jsp .
In box 1, select Succession->Succession Enterprise