User's Manual

10
4. After you have attached the stand to the 4612/4624 IP telephone, use the screw provided to
tighten the stand onto the back of the telephone set.
5. Plug the telephone’s foot-long CAT 5 line cord into the primary Ethernet line interface jack
(identified by an icon that looks like a modular wall jack).
6. Place the other end of the line cord through the round hole in the middle of the stand, and
snake it out through the rectangular opening in the center of the stand.
7. If a connection to the Ethernet hub and secondary interface jack is required, plug the 14-foot
CAT 5 line cord into the adjacent jack (identified by an icon on the right that looks like a stylized
PC). Temporarily drape the cord over the front of the telephone.
8. Plug the line cord into the wall jack.
L
I
N
E
A
D
J
LINE
ADJ